NETCTL-AUTO(1)
==============

NAME
----
netctl-auto - Control automatic selection of wireless netctl profiles


SYNOPSIS
--------
*netctl-auto* {*COMMAND*} ...

*netctl-auto* [--help | --version]


DESCRIPTION
-----------
*netctl-auto* may be used to control the automatic network profile selection
offered by the 'netctl-auto@.service' file. See *netctl.special*(7) for
details about the service file.


OPTIONS
-------
The following commands are understood:

*list*::
    List all profiles which are currently available for automatic selection.
    Active profiles will be marked with a '*', disabled profiles will be
    marked with a '!'.

*current*::
    Report currently active profiles.

*switch-to [+PROFILE+]*::
    Switch to the network profile specified on the command line. The
    specified profile will be enabled if necessary, the state of all other
    profiles is not changed. This command does not force *netctl-auto* to use
    the specified profile. If a disconnect occurs, *netctl-auto* may select
    an alternative profile.

*enable [+PROFILE+]*::
    Enable a previously disabled network profile for automatic selection.
    Every time the *netctl-auto* service is started, all available profiles
    are enabled by default.

*disable [+PROFILE+]*::
    Disable the specified profile for automatic selection. This will only
    take effect until the *netctl-auto* service is stopped.
    To permanently exclude a profile from automatic selection, use the
    'ExcludeAuto=yes' option in the profile.

*enable-all*::
    Enable all profiles for automatic selection.

*disable-all*::
    Disable all profiles for automatic selection.

*start [+INTERFACE+]*::
    Start automatic profile selection on the specified interface. +
    This command should not be invoked directly, use the following command
    instead:
---------------------------------------------
    systemctl start netctl-auto@<interface>
---------------------------------------------

*stop [+INTERFACE+]*::
    Stop automatic profile selection on the specified interface. This will
    disconnect the currently active profile on the interface. +
    This command should not be invoked directly, use the following command
    instead:
--------------------------------------------
    systemctl stop netctl-auto@<interface>
--------------------------------------------


EXIT STATUS
-----------
On success 0 is returned, a non-zero failure code otherwise.


ENVIRONMENT
-----------
'$NETCTL_DEBUG'::
    If set to +"yes"+, debugging output is generated.


SEE ALSO
--------
*netctl*(1), *netctl.profile*(5), *netctl.special*(7)
